The mount for the main-sheet bridle have been main along side of the rear spinnaker block mounts. I used the same lay-up of uni and DB carbon-fibre that was used in making the chain-plates. It should, fingers crossed all be nice and strong or the whole boat will fall apart, one or the other.
The v-berth has been started with the supports for the actual 'bunks' being glued in today which should mean the 'bunks' themselves will go in tomorrow ( two pieces of 6mm ply to cover the area forward). The porta-potti will be located just in front of the compression post in the v-berth, this will make the v-berth 'cozy' to say the least.
As you can see the compression post (carbon) has also gone in.
As you can see the compression post (carbon) has also gone in.
The fore-stay is on, same lay-up as everything else, so its great or not, we will see.
No comments:
Post a Comment